Crank, bearings, hardware, and sprocket installation.
Install a 3.5" 1 piece crank, bearing, and a 36T sprocket onto a 20" lowrider frame.
step 1 - slide the crank to the sprocket, slip on the W2 washer
step 2 - screw on the S2 bearing race nut to the sprocket thread
step 3 - slide bearing 1 with the balls facing up
step 4 - insert the crank/sprocket/bearing 1 into the frame
step 5 - slide bearing 2 with the balls facing down
step 6 - screw on the S1 bearing race nut to the sprocket thread
step 7 - slide on the W1 lock washer
step 8 - screw the S3 hex nut to the sprocket thread to finish
© Copyright 2006 BicycleDesigner.com - bicycles